User's Manual

1750
Operators Manual
28
Navigating in Power View on the PDA
The Menu Bar on the bottom of the Power View screen allows you to quickly and easily
configure a connected Recorder, view live data, and transfer data to the Secure Data (SD)
card for viewing and analysis on your desktop computer using the companion Power
Analyze software.
Power View Menus
Data
Brings up the memory management screens which are for download to the SD card
inserted in the Recorder and for erasing Recorder internal memory erasing and SD card
files.
View
Brings up a list of the live detail views: Scope, Meter, Phasor, Harmonics, and Trend.
There are configurable detail views of each type of screen available by tapping the sector
of interest or the View menu. Once a detail view is selected, navigation to all available
detail views is accomplished using the View menu.
Setup
Brings up the Recorder Setup menu, which allows you to configure the Recorder and set
recording period information. Using this function, you can tap the appropriate icon to set
the following :
• Clock
• Nominal Volts
Nominal voltage and frequency values are auto-detected by the Recorder and
shown as the defaults. These settings can be overwritten, forcing the Recorder to
change its internal configuration to optimize power quality data recording for
custom settings.
• Volts and Current Scale
• Passwords
• Power Type Diagrams
• Phase Swap
• Probe Detect
Icons on the Menu Bar
Toggles between voltage and current waveforms. The PHASOR screen always shows
both V & I (volts and amps). This icon is replaced with the icon on the detail
views, as voltage and current data can be viewed simultaneously.
In all the detail live view screens, a line selection menu is available using the
button at
the bottom. This is a checkbox that is used to select the voltage and current channels you
want to display.
This icon triggers the Recorder to capture high-resolution waveform data and save it in
the recorded data stream. This waveform capture is identical to the “snapshot period”
which can set up to happen automatically in the Recorder Setup menu.