User's Manual

Operators Manual
Safety Information
3
Safety Information
The Recorder complies with EN 61010-1 600 V, CAT IV, 1000 V CAT III overvoltage
rating. See the Specifications section for a full agency compliance list.
XWWarning
To avoid electrical shock or fire:
Review the entire manual before using the Recorder and its
accessories.
Avoid working alone.
Do not operate the Recorder around explosive gas or vapor.
Use only insulated current probes, test leads, and adapters as
supplied with the Recorder, or indicated as suitable for the
Recorder.
Before use, inspect the Recorder, voltage probes, current clamps,
leads, and accessories for mechanical damage, and replace when
damaged. Look for cracks or missing plastic. Pay special attention
to the insulation surrounding the connectors.
Remove all probes, test leads, and accessories that are not in use.
Make sure the Recorder is properly connected through the power
cord to protective earth ground.
Do not apply input voltages above the rating of the Recorder as
shown on the input panel.
Do not apply voltages in excess of the marked ratings of the voltage
probes and current clamps.
Do not use exposed metal BNC or banana plug connectors.
Do not insert metal objects into connectors.
Never open the Recorder’s enclosure, dangerous voltages are
present. There are no user replaceable parts in the Recorder. Refer
servicing of internal parts to qualified service personnel
Use the Recorder only as specified in this manual, or the protection
provided by the Recorder may be impaired.