User Manual
Table Of Contents
- Ti100, Ti110, Ti125, TiR110, TiR125 Users Manual
- Introduction
- How to Contact Fluke
- Safety Information
- Accessories
- Before You Start
- Features and Controls
- Focus
- Primary and Secondary Triggers
- How to Use the Control Buttons
- How to Use the Menus
- Image Capture
- SD Memory Card
- Temperature Measurement
- SmartView( Software
- Menus
- Maintenance
- General Specifications
- Detailed Specifications
Thermal Imagers
Menus
29
Compass
The Imager (not applicable for Ti100) includes an eight-point cardinal
compass on the display. The compass has on and off functions. This compass
lets you accurately record the target locations for analysis and reports.
To set the compass:
1. Push .
2. Push / to highlight Camera.
3. Push or to view the menu.
4. Push / to highlight Compass.
5. Push or to view the menu.
6. Push / to highlight ON or OFF.
7. Push to set the option.
8. Push:
• to go back to the live view.
• or to go back to the previous menu.
• to cancel the change and go back to the live view.
Note
W shows on the display when the compass cannot make a reading.
Video
The Ti110, Ti125, TiR110, TiR125 have .avi (with mpeg encoding) video
capture for a maximum of five minutes. The controls include stop, rewind, fast
forward, and pause/play functions. For the Ti125 and TiR125, the thermal
scene and complexity of the recorded data affects the amount of time (2.5 to
5 minutes) available for Radiometric (.is3) video recording. Streaming video
output (Ti125, TiR125 only) is available with the USB connection to a PC
with SmartView software.
The Video selection toggles between Video Off, Video/Audio, and Video
Only. The video capture format is set in the Settings menu. For more
information, see page 34.
To set:
1. Push .