User Manual
Table Of Contents
- Ti100, Ti110, Ti125, TiR110, TiR125 Users Manual
- Introduction
- How to Contact Fluke
- Safety Information
- Accessories
- Before You Start
- Features and Controls
- Focus
- Primary and Secondary Triggers
- How to Use the Control Buttons
- How to Use the Menus
- Image Capture
- SD Memory Card
- Temperature Measurement
- SmartView( Software
- Menus
- Maintenance
- General Specifications
- Detailed Specifications
Ti100, Ti110, Ti125, TiR110, TiR125
Users Manual
18
If you set a value that is <0.60, W shows on the Imager display with this
caution:
W
Caution:
Emissivity <0.6
(see Manual)
Note
Surfaces with an emissivity of <0.60 make reliable and consistent
determination of actual temperatures problematic. The lower the
emissivity, the more potential error is associated with the Imager's
temperature measurement calculations. This is also true even when
adjustments to the emissivity and reflected background adjustments
are performed properly.
Emissivity is set directly as a value or from a list of emissivity values for some
common materials.
Note
If the Display is set to Display All, you see the information about
current emissivity as ε = x.xx.
Adjust by Number
To set the emissivity value:
1. Push .
2. Push / to highlight Measurement.
3. Push or to view the menu.
4. Push / to highlight Emissivity.
5. Push or to view the menu.
6. Push / to highlight Adjust Number.
7. Push or to view the menu.
8. Push / to change the value.
9. Push:
• to set the change and go back to the live view.
• or to set the change and go back to the previous menu.
• to cancel the change and go back to the live view.