User Manual
Table Of Contents
- Ti100, Ti110, Ti125, TiR110, TiR125 Users Manual
- Introduction
- How to Contact Fluke
- Safety Information
- Accessories
- Before You Start
- Features and Controls
- Focus
- Primary and Secondary Triggers
- How to Use the Control Buttons
- How to Use the Menus
- Image Capture
- SD Memory Card
- Temperature Measurement
- SmartView( Software
- Menus
- Maintenance
- General Specifications
- Detailed Specifications
Thermal Imagers
SD Memory Card
13
2. Pull the trigger to capture the image. The image is now in the buffer and
you can save or edit.
3. Push to save the image as a file and go back to the live view.
SD Memory Card
To eject an SD memory card, push in on the exposed edge of the card and then
release. The card should pop partially out after you release it. Carefully pull
the card out of the slot.
To use the SD memory card, make sure that the write-protect lock is open. See
Figure 2. Carefully push the card into the slot with the card label facing away
the LCD. Push the card in until it catches.
gju03.eps
Figure 2. SD Memory Card Insertion and Removal
For information about how to save data, see page 12. For information about
how to view or erase a stored image, see page 33.