User's Manual

Wireless Multimeter
MIN MAX AVG Record Mode
9
How to Unbind a Module from the Product
You can use one of three different procedures to unbind a
module from the Product.
• Turn off the module.
• Push  on the module to turn off the radio in the
module. The module stays on to continue
measurements.
• Push  on the Product to select the module you
want to unbind and then push . All other
modules stay bound to the Product.
How to Set the Product to Module Mode
You can set the Product to operate as a module so its
measurements can be shown on different DMM setup as
a master. To set the Product to the module mode:
1. Push and hold .
2. Turn on the Product.
3. Release  after MOD shows in the display.
Note
The radio is always turned on when the Product
is in the module mode.
When the radio on a different DMM is turned on and the
discovery procedure starts, the Product is discovered and
a number shows in the display of the Product.
MIN MAX AVG Record Mode
The MIN MAX AVG record mode records the minimum
and maximum input values, and calculates a running
average of all measurements. The Product beeps when a
new high or low is sensed.
Note
For dc functions, accuracy is the specified
accuracy of the measurement function,
± 12 counts for changes longer than 250 ms in
duration.
For ac functions, accuracy is the specified
accuracy of the measurement function
± 40 counts for changes longer than 900 ms in
duration.
To start a MIN MAX AVG record session:
1. Make sure the Product is set to the correct
measurement function and on the correct range.
Autorange is disabled while in a MIN MAX AVG
record session.