User's Manual
Table Of Contents
- 3000 FC Users Manual
- Introduction
- How to Contact Fluke
- Safety Information
- Hazardous Voltage
- Test Lead Alert
- Battery Saver
- Remote Operation
- MIN MAX AVG Record Mode
- Display Hold
- Yellow Button
- Display Backlight
- Manual and Auto Range
- Power-Up Options
- Features
- AC Zero Input Behavior of True-rms Meters
- Basic Measurements
- Maintenance
- Service and Parts
- Specifications
Wireless Multimeter
Remote Operation
7
When the Product completes the discovery procedure,
stops flashing in the display.
Note
If modules are not discovered after 2 minutes,
the radio turns off.
At the end of the discovery procedure, all discovered
modules shown in the display have a black number on a
grey background. See Figure 1. This shows the modules
to which the Product is bound. Although the display can
only show three modules, the Product can discover and
temporarily bind to a maximum of six modules.
Note
To bind a module to the Product after the
discovery procedure has completed, you must
turn off the radio. Turn on the radio again to start
the discovery procedure.
The number of the module at the top of the list flashes to
show it is highlighted. Push to move the highlight to
the next module in the list.
The Product stays in the module selection mode for
approximately 2 minutes. To select a module to bind to
the Product:
1. Push until you highlight the module to bind.
Note
The radio button () on the module highlighted
in the list flashes at a faster rate. This helps
identify the highlighted module.
2. Push . The number of the selected module will
change to a grey number on a black background.
See Figure 1.
3. Do steps 1 and 2 again for each module to bind to
the Product. The Product can bind to a maximum of
three modules.
4. You can wait for the module selection time to
complete or push and hold for 2 seconds to end
the module selection mode.