User's Manual

Table Of Contents

Wireless Multimeter

Hazardous Voltage

The display shows  and the hazardous voltage indicator

illuminates red when a hazardous voltage (≥30 V) is

present on the input of the Product

Test Lead Alert

The display shows LEAD for a second when you turn the

function switch to or from the mA position to remind you

to make sure the test leads are in the correct terminals.

Battery Saver

The Product goes into “Sleep mode” and turns off the

display if there is no function change or button pushed for

20 minutes. To turn off the sleep mode, push

while

you turn on the Product. The sleep mode is always turned

off for a MIN MAX AVG record session and when remote

modules are shown in the display.

Remote Operation

The Product uses low-power 802.15.4 wireless

technology to show measurements from a maximum of

three 3000 FC Series Wireless Modules. One of the

wireless modules can be a 3000 FC Wireless Multimeter.

The Product cannot control other DMMs or modules. The

wireless radio does not cause interference with meter

measurements.

Radio Frequency Data

Note

Changes or modifications to the wireless

2.4 GHz radio not expressly approved by Fluke

Corporation could void the user’s authority to

operate the equipment.

This Product complies with Part 15 of the FCC Rules.

Operation is subject to the two conditions that follow: (1)

this device can not cause interference, and (2) this device

must accept any interference, including interference that

can cause undesired operation of the device.

Class B digital device: A digital device that is marketed for

operation in a residential environment notwithstanding

use in commercial, business and industrial environments.

Examples of such devices include, but are not limited to,

personal computers, calculators, and equivalent

electronic devices that are marketed for operation by the

general public.