User's Manual

Tag Operation
Table 1. Tag Mode LED Indications
Action Right LED Left LED Status
Periodic or motion
activated scan.
2x Green blink - Successful scan and send results to
Positioning Engine.
Periodic or motion
activated scan.
2x Red blink - Unsuccessful scan or unsuccessful
results send.
Blue button press. 1x Orange +
2x Green blink or
2x Red blink
- Success green.
Unsuccessful scan or results send
red.
Blue button press. 2x Green blink or
2x Red blink
1x Orange Success green.
Unsuccessful scan or results send
red.
Activation.
Blue button 3 seconds.
1x Orange 1x Orange +
6x Red blink +
2x Green blink or
2x Red blink
Both LEDs blink orange after button
press. Left LED blinks during
activation. Finally left LED blinks
green or red. Green indicates
successful activation.
Button Scan
Pressing the blue or green button sends a scan command to the tag. After the button press, the tag
immediately scans and sends the results to Positioning Engine. The LEDs indicate the scan
success or failure similarly as in the scan activated by the wakeup interval.
Resetting to Factory Settings
The Beacon100 can be reset to factory setting by either pressing a button sequence or by
opening the back cover and removing the batteries.
To reset the Beacon100 using buttons with a button sequence, do the following:
1. Press the
blue button until left LED flashes orange.
2. When the left LED flashes orange, press the
green button immediately.
3. After approximately 2 seconds both LEDs flash orange.
4. The tag has now been reset to factory settings. The tag is in reset mode when it does
not executing button scan as defined in the “Button Scan” section.
Firmware Update
The tag firmware can be updated wirelessly using Positioning Engine. The firmware is
uploaded to the Beacon100 from the Tag Properties page in Positioning Engine. Follow
instruction in the Fluke Biomedical Positioning Engine Users Guide for updating
firmware.
3