User's Manual

Vibration Meter
About Measurements
23
5. Push  to set the category and open the
RPM Range menu.
By default, the RPM range is set to >600 RPM and
is correct for most applications. To change the
RPM range: push  and  to highlight the RPM
Range.
6. Push  to set the range and open the
Create Setups menu for the First Level ID.
gqi94.jpg
7. Push    and  to highlight a letter or number.
8. Push  to set the letter or number.
9. Repeat steps 8 and 9 to make a unique name for
the setup.
10. Push .
The Meter prompts you to give the setup a Second
Level ID. The Yes option opens the menu to key in
a name for the ID.
11. Push .
You can continue this process and set up as many
Second Level IDs as necessary for the job. For
example, you can enter the bearing number that
the measurement is taken from, such as,
Bearing_1 on FAN1.
When done, select No to go back to the Setup
menu. To recall a setup, see View Setups on
page 29.