User manual

2638A
Users Manual
4-14
Record
The Record function saves the scan or DMM measurement results to a file that can be
transferred to a PC for further evaluation. When the Product is recording data, the
Record key is illuminated and “RECORDING” shows on the top of the display. Data is
recorded for as long as the key is illuminated and “RECORDING” shows on the display.
Note
Scans can be completed without recording the results. In this scenario, the
data is saved to temporary memory and will be overwritten the next time a
scan is started or if the temporary memory becomes full (approximately
60,000 readings).
Record Measurement Data
For the Scan function, the behavior of the Record key is dependent on the Auto
Recording setting in the Test Setup menu. If set to ON, the Product automatically records
the scan data when the scan is started. If set to OFF, the user must manually push

to record scan data to file after the scan is started.
Note
Auto Recording is associated only with the Scan/Monitor function and does
not work with the DMM function. To record a DMM measurement, push
 to start recording DMM data regardless of the Auto Recording
setting in the Test Setup menu.
Each time a scan or a DMM measurement is recorded, a new data folder is made with a
unique timestamp so that it can be easily found and managed (see “Open a Data File on a
PC”). Data files made from a scan are saved in the scan folder and the DMM data files
are saved in the DMM folder.
Note
Scan data or DMM data stored directly to the USB drive is not visible to
the user through the Memory menu. However, the Memory menu shows the
user how much memory is available on the USB drive. To manage the scan
data files on the USB drive, connect the USB drive to a PC and open the
folder named “Scan Data” or “DMM Data”.