Instructions

Bit 2 Channel 2 temperature measure bit.
Bit 3 Channel 2 humidity measure bit.
Bit 4 Channel 1 sensor attached/detached.
Bit 5 Channel 2 sensor attached/detached.
Bit 6 Not used.
Bit 7 Not used.
Example: STAT:MEAS?
Response: 3
8.2.11.14 STATus:MEASure:CONDition?
This command reads the Measurement Status Condition Register. Reading this
register does not affect it. The value returned indicates the condition of each of
the eight bits of the register by adding the binary-weighted values of each bit.
The meaning of each bit, when set (1), is as follows where 0 is the least signifi-
cant and 7 is the most significant:
Bit 0 Channel 1 temperature measure bit.
Bit 1 Channel 1 humidity measure bit.
Bit 2 Channel 2 temperature measure bit.
Bit 3 Channel 2 humidity measure bit.
Bit 4 Channel 1 sensor attached.
Bit 5 Channel 2 sensor attached.
Bit 6 Not used.
Bit 7 Not used.
Example: STAT:MEAS:COND?
Response: 15
8.2.11.15 STATus:MEASure:ENABle?
This command returns the Measurement Status Enable Register (see STA
-
Tus:MEASure:ENABle <num> command below).
Example: STAT:MEAS:ENAB?
Response: 15
8.2.11.16 STATus:MEASure:ENABle <num>|MIN|MAX|DEF
This command sets the Measure Status Enable Register. This register deter
-
mines which event bits of the Measure Status Event Register affect the Measure
127
8 Digital Communications Interface
Commands