User manual
Table Of Contents
- Table of Contents
- 1 Before You Start 1
- 2 Introduction 7
- 3 Specifications and Environment Conditions 9
- 4 Quick Start 13
- 5 Parts and Controls 15
- 6 General Operation 17
- 7 Controller Operation 19
- 7.1 Target Temperature 19
- 7.2 Temperature Set-point 19
- 7.3 Temperature Scale Units 21
- 7.4 Scan 22
- 7.5 Set-point Resistance 23
- 7.6 Temperature Scale Units 23
- 7.7 Secondary Menu 23
- 7.8 Heater Power 23
- 7.9 Proportional Band 24
- 7.10 Controller Configuration 25
- 7.11 Operating Parameters 25
- 7.12 Serial Interface Parameters 26
- 7.13 Calibration Parameters 27
- 8 Digital Communication Interface 29
- 9 Calibration Procedure 35
- 10 Maintenance 39
- 11 Troubleshooting 41
- Figures
- Tables
ranty extends only to the original purchaser and shall not apply to any
product which, in Hart’s sole opinion, has been subject to misuse, alteration,
abuse or abnormal conditions of operation or handling.
Software is warranted to operate in accordance with its programmed in
-
structions on appropriate Hart products. It is not warranted to be error free.
Hart’s obligation under this warranty is limited to repair or replacement of a
product which is returned to Hart within the warranty period and is deter
-
mined, upon examination by Hart, to be defective. If Hart determines that
the defect or malfunction has been caused by misuse, alteration, abuse or
abnormal conditions or operation or handling, Hart will repair the product
and bill the purchaser for the reasonable cost of repair.
To exercise this warranty, the purchaser must forward the product after call
-
ing or writing Hart for authorization. Hart assumes NO risk for in-transit
damage.
For service or assistance, please contact an Authorized Fluke Hart Scientific
Service Center (see Section 1.3).
THE FOREGOING WARRANTY IS PURCHASER’S SOLE AND EXCLUSIVE REM-
EDY AND IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OR MERCHANT-
ABILITY, OR FITNESS FOR ANY PARTICULAR PURPOSE OR USE. FLUKE HART
SCIENTIFIC SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDEN-
TAL, OR CONSEQUENTIAL DAMAGES OR LOSS WHETHER IN CONTRACT,
TORT, OR OTHERWISE.
11
3
Specifications and Environment Conditions