User manual

v
9.4.1 Hold Temperature Display ............................................................................35
9.4.2 Mode Setting ................................................................................................35
9.4.3 Switch Wiring ................................................................................................36
9.4.4 Switch Test Example ....................................................................................36
9.5 Secondary Menu .................................................................................... 36
9.6 Heater Power .......................................................................................... 37
9.7 Proportional Band .................................................................................. 37
9.8 Cutout .................................................................................................... 38
9.9 Controller Configuration .......................................................................... 39
9.10 Operating Parameters ............................................................................ 39
9.10.1 Stir Speed ......................................................................................................39
9.10.2 High Limit .....................................................................................................40
9.10.3 Cutout Reset Mode .......................................................................................40
9.11 Serial Interface Parameters ................................................................... 41
9.11.1 BAUD Rate ....................................................................................................41
9.11.2 Sample Period ...............................................................................................41
9.11.3 Duplex Mode .................................................................................................42
9.11.4 Linefeed .......................................................................................................42
9.12 Calibration Parameters ........................................................................... 43
9.12.1 R0 .................................................................................................................43
9.12.2 ALPHA ..........................................................................................................43
9.12.3 DELTA ...........................................................................................................43
9.12.4 C0 and CG ....................................................................................................44
9.12.5 rCAL ..............................................................................................................44
10 Digital Communication Interface ..........................................45
10.1 Serial Communications .......................................................................... 45
10.1.1 Wiring ...........................................................................................................45
10.1.2 Setup ............................................................................................................45
10.1.2.1 Baud Rate ........................................................................................................... 46
10.1.2.2 Sample Period ...................................................................................................... 46
10.1.2.3 Duplex Mode ........................................................................................................ 46
10.1.2.4 Linefeed ................................................................................................................ 46
10.1.3 Serial Operation ............................................................................................46
10.2 Interface Commands .............................................................................. 47
11 Test Probe Calibration ...........................................................49
11.1 Calibrating a Single Probe ..................................................................... 49
11.2 Stabilization and Accuracy .................................................................... 49