User manual

6102 Micro-Bath User’s Guide

Front Panel

Fan – The fan inside the calibrator runs continuously when the unit is being op erated

to provide cooling for the instrument. Slots at the top and around the two cor ners of

the calibrator are provided for airÀow. The area around the calibrator must be kept

clear to allow adequate ventilation. The airÀow is directed out the back.

Front Panel7. 2

Refer to Figure 2 on this page.

Controller Display – The digital display is an important part of the temperature

controller because it not only displays set and actual temperatures but also dis plays

various calibrator functions, settings, and constants. The display shows temperatures

in units according to the selected scale °C or °F.

6102 Front PanelFigure 2

Controller Keypad – The four button keypad allows easy setting of the set-point

temperature. The control buttons (SET, DOWN, UP, and EXIT) are used to set the

calibrator temperature set-point, access and set other operating parameters, and access

and set calibration parameters.

Setting the control temperature is done directly in degrees of the current scale. It can

be set to 0.01 degrees Celsius or Fahrenheit.

The functions of the buttons are as follows:

SET – Used to display the next parameter in the menu and to store parameters to the

displayed value.

DOWN – Used to decrement the displayed value of parameters.

UP – Used to increment the displayed value.

EXIT – Used to exit a function and to skip to the next function. Any changes to the

displayed value are ignored. Holding the EXIT button for approximately 0.5 seconds

exits back to the main display.

SET

DOWN EXIT

200.00C

MICRO-BATH 35°C to 200°C

6102