User manual

Fluke DAQ
Users Manual
Configuration Dialogs
The Configuration dialog that is shown with the toolbar
configuration icon selected depends on the node
(device, module, or channel) selected in the TreeView
panel.
Copy and paste functionality can also be used to save
configuration time. Channel settings can be copied from
one channel to another in the same device, or an entire
module or a group of channel settings can be copied from
one device to another.
To copy a channel:
1. Highlight the channel to be copied.
2. Right-click the mouse and select Copy.
3. Highlight the module where the channel is to be
added.
4. Right-click the mouse and select Paste.
A new channel with the same configuration is added to
the module.
The same method can be used to change channel
settings:
1. Highlight a channel.
2. Right-click the mouse and select Copy.
3. Highlight the channel to be changed.
4. Right-click the mouse and select Paste to paste the
configuration information.
Note
When moving from a Configuration dialog to a
Communication dialog, the device that was
previously selected in the dialog is still selected.
For example, if device 01 is selected in the
Configuration dialog and you move to a
Communication dialog, the device will only be
highlighted if it was selected the last time you
were in the Communication dialog. Dialog
selections are remembered and are
independent.
The Software uses the Configuration dialogs that are in
the next sections.
10