Information

12
2680 Series Chassis
General
specifications
Power
100 V ac to 240 V ac, 50 Hz or
60Hz
100 VA max, or 9 V dc to 45 V dc
(50 W max—all slots filled +
memory card installed) (if both
sources are applied simultaneously,
the greater of ac or dc is used.), at
120 V ac the equivalent dc voltage
~14.5 V
Temperature, humidity
(non-condensing)
Operating:
-20 °C to 28 °C, ≤90 % RH;
28 °C to 40 °C, ≤75 % RH;
40 °C to 60 °C, ≤50 % RH
Storage:
-40 °C to 70 °C, 5 % to 95 % RH
Altitude
Operating: 2000 m
Storage: 12,200 m
Standards
All inputs: IEC Measurement
Category II
Product conforms to the following
safety and emission standards:
EN610000-4-2,3,4,6,8
EN61326
EN61010-1, CAT II
CAN/CSA C22.2 No. 61010-1:2004
Operating temperature
-20 °C to 60 °C (-4 °F to +140 °F)
Storage temperature
-40 °C to 70 °C (-40 °F to +158 °F)
Ordering
information
Hardware
2680A
Data Acquisition System Chassis, 6 slots
2686A
Data Logging System Chassis, 6 slots, with
ATA Flash memory drive, includes 1 GB
ATA flash memory card
2680A-FAI
Fast Analog Input Module 20 universal
channels, 50 V max isolation. 1000 ch/sec
scan rate, 16 bit resolution
2680A-PAI
Precision Analog Input Module 20
Universal Channels, 300 V max isolation,
18 bit resolution 140 ch/sec scan rate
2680A-DIO
Digital I/O and Relay Module, 20 DIO, 8, 1
A Contacts, Totalizer (one per chassis max)
Software
2680A-APSW
Fluke DAQ Configuration Software and
extra license for 2680 Series (included
with 2680A and 2686A)—Full Version
2680A-904
Trend Link for Fluke
Accessories
2680A-180
Universal Input Module, Extra Connector
2680A-102
2680A-DIO Connector Module, Extra
Connector
2620A-101
Shunt resistor set (12 ea), 10 W, 0.1 %
2680A-810
1 GB ATA Flash Memory Card for 2686A
Y2680
19-inch Rack Mount Kit for 2680 Series
Size
473 mm x 423 mm x 237 mm
(18.6 in x 17 in x 9.3 in)
Weight
2680A/2686A chassis only:
8.47 kg (18.86 lbs.)
2680A-FAI: 0.79 kg (1.74 lbs.)
2680A-PAI: 1.21 kg (2.66 lbs.)
2680A-DIO: 0.80 kg (1.75 lbs.)
Interfaces
Ethernet: Conforms to IEEE 802.3
Ethernet standard,
compatible with 100 BaseT and
10 BaseT standards, uses TCP/IP
protocol
RS-232C: For calibration only
System Requirements
• Processor 32/64 bit, 1 GHz
• Microsoft Windows
®
Vista/7/8
• 8 GB RAM
• 3 GB free hard disk space
• VGA or SVGA display, 100 %
IBM compatible with 2 MB Video
RAM (VRAM)
• CD-ROM drive