User's Guide

Table Of Contents

Figure 7.5: Wireless parameters conﬁguration. Basic mode

make sure the country has been properly speciﬁed before changing the fre-

quency of the system.

Frequency Selectors. All Fluidmesh units are equipped with multi-band

radios capable of operating on the 4.9-6 GHz bands.

You can change the

frequency of each radio in order to minimize interference with other wire-

less networks operating in the same area. The frequencies listed on the

Frequency Selector are the carrier frequencies. In Basic mode, each ra-

dio operates using ﬁxed channel carriers with 40 MHz channel widths as

speciﬁed by the local country regulations. In Advanced mode, the user is

allowed to select any channel carrier in the local country frequency band

with a 5 MHz granularity. The channel width can be set through the speciﬁc

selector (see below). Make sure you pick non-overlapping channels if you

need to operate more than one unit in the same area.

In Advanced mode, the following selectors are also available:

4.9 GHz and 6 GHz are licensed bands which must be enabled through the proper

software plug-in. Please refer to Section 7.13 for details.