User's Manual

The Fluidmesh VLAN implementation is compatible with the specification
of the IEEE 802.1q standard and, thus, the Fluidmesh network can inter-
operate with other VLAN-aware network devices. VLAN trunking between
the Fluidmesh network and Ethernet switches is also supported and can
be enabled by selecting the proper control in the unit’s callout window. En-
abling VLAN trunking on a specific port instructs the FM unit to forward
VLAN membership information to the device connected to the port, thus
extending VLANs across multiple network devices.
To simplify the configuration of the units when trunking is enabled, a special
VID #1 is available. Simply configuring the network switch with a VLAN #1
will allow any PC belonging to the VLAN #1 to access the web interface of
the FM units without the need for additional settings of the FM units.
7.12 Firmware Upgrade
Through the firmware upgrade page (Fig. 7.16), it is possible to upgrade
the Firmware of the devices to the latest version available. To do so, down-
load the latest Firmware upgrade file to your PC from the Fluidmesh Net-
works Web site at www.fluidmesh.com.
4
Select the correct file on your hard
disk, and upload it. This operation might take several minutes. The unit will
automatically reboot at the end of the upgrade process.
Upgrading a working system is always a delicate and somewhat risky oper-
ation. Fluidmesh discourages anybody from upgrading a functional system
except if there is an issue to fix.
Recommended upgrading procedure for running systems:
1. Download the latest firmware release available for your hardware/firmware
family;
2. Power off the whole network;
3. Power on one device at a time;
4. Connect directly to the Fluidmesh unit to be upgraded directly through
an Ethernet cable;
5. Write down the unit configuration (at least network settings and wire-
less settings);
4
An approved Fluidmesh extranet account is required. Please register for a an on-line
account and contact Fluidmesh for approval.
54