User's Manual

38
wireless networks. To redirect a traffic flow to a Mesh Point, you must specify all the multicast
flows redirection information within the Mesh End multicast page as shown in Fig 7.19.
Figure 7.20: Add/Remove Multicast Routes Towards Mesh Points
7.18 Change Password
Use this page to change the password to access the unit Web GUI.
7.19 Status
This page reports a summary of the status of the unit. The MAC address of the radio is published on
the status page as well. In case of system malfunctions, the unit’s diagnostic file dump can be
downloaded through this page and emailed to the Fluidmesh technical support to facilitate the
problem diagnosis. Additionally, the unit log can be viewed. The information of the log is relative to
possible flapping of the Ethernet port and provides information about possible duplicate IPs present in
the LAN. Please refer to Table 7.6 for a detailed description of the log messages.