User's Manual

19
Figure 7.5: Wireless Parameters Configuration-Basic Mode
Please make sure the country has been properly specified before changing the frequency of the
system.
Frequency Selectors: All Fluidmesh units are equipped with multi-band radios capable of operating
on the 4.9-6 GHz bands
5
. You can change the frequency of each radio in order to minimize
interference with other wireless networks operating in the same area. The frequencies listed on
the Frequency Selector are the carrier frequencies. Please note that when the unit is forced to be
“SLAVE” of a point-to-multipoint topology, the frequency is NOT selectable. In fact, the SLAVE
will scan for the relative “MASTER” according to the configuration of the “MESH Cluster ID”
described in Section 7.8. The frequency selector in Mesh Point configured as slave will be available
by unchecking the autoscan box in advance radio settings page.
5
4.9 GHz must be enabled through the proper software plug-in. Please refer to Section 7.13 for details. Not
available in Brazil and Canada.