User's Manual

13
(b)
Plug-in Deactivation
Figure 6.2: Activation/Deactivation Code
Generation Web interface available at www.fluidmesh.com.
7 FMQuadroWeb Based Interface and Configuration
Every FM unit can be configured and managed using a Web-based Graphical User Interface
(GUI). By default, each FM unit is configured in Bridge Mode with the Bridge IP address
192.168.0.10 and netmask 255.255.255.0.
To change the settings on the units, you need to log-in to the Web- based interface.
7.1 Software and Hardware Requirements
To log-in to the Web GUI, you need a PC with a Web-browser, an Ethernet port, and an Ethernet
cable.
Requirements List:
Cat5 / 6 Ethernet cable with RJ45 connectors.
PC with the following characteristics:
Windows XP or Windows 2000. In this manual, we assume use of Windows XP and
every instruction or screenshot is based on this assumption. The device can also be
configured using other operating systems, such as Linux, MAC OS, or older versions of
Windows.
Chrome. In this manual, we suggest theuse of Chrome. A Fluidmesh device can also be
configured using other browsers such as older versions of Internet Explorer, Firefox or
Safari but the configuration using these browsers has not been thoroughly tested.
Wired Ethernet Network Card.
Hardware Requirements. Typical PC hardware allowing for proper operations of
Windows XP and Microsoft Internet Explorer 6.