User's Manual
20
Fig. 7.5 - Wireless Parameters Configuration-Basic Mode
Please make sure the country has been properly specified before changing the frequency of the system.
Frequency Selectors: All Fluidmesh units are equipped with multi-band radios capable of operating
on the 4.9-6 GHz bands
5
. You can change the frequency of each radio in order to minimize interference
with other wireless networks operating in the same area. The frequencies listed on the Frequency
Selector are the carrier frequencies. Please note that when the unit is forced to be “SLAVE” of a point-
to-multipoint topology, the frequency is NOT selectable. In fact, the SLAVE will scan for the
relative “MASTER” according to the configuration of the “MESH Cluster ID” described in Section 7.8.
The frequency selector in Mesh Point configured as slave will be available by unchecking the autoscan
box in advance radio settings page.
To avoid network co-location interference, it is advised to have the frequencies as far apart as possible.
5
4.9 GHz must be enabled through the proper software plug-in. Please refer to Section 7.13 for details. Not
available in Brazil and Canada.