User's Manual

4
done properly, the RJ45 connectors can be plugged into the relative Ethernet port of the FM radio and
the bottom can be locked using the self-retaining screws on the sides of each FM radio.
Figure 3.4: Shielded CAT5/6 Connector
3.3 Factory Default Hardware Reset
The FM radios can be reset to factory default using the proper RESET button present at the bottom
of the unit. To reset the radio to factory default settings, power up the unit and wait approximately
40 seconds for the unit to boot up. Once the unit is up and running, press the reset button for 7
seconds. The radio will restore the factory default settings and automatically reboot. The LEDs
will blink when the unit receives the reset to factory default signal. After the reset, the default IP
address of 192.168.0.10/255.255.255.0 is restored and the administrator password is set to admin.
The RESET button can also be used to reboot the unit when pressed for 1 second.