User's Manual

1. Antenna Alignment: the two antennas must be aligned toward each other.

2. Line of Sight: you must have clear line of sight between the two antennas.

3. Power: check if the FM unit is properly powered-on with the provided PoE injector.

4. Channel: both FM unit units must be operating on the same channel.

APPENDIX A

Federal Communication Commission Interference Statement

This equipment has been assembled with components that comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a commercial environement. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

Operation of this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his own expenses.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on

a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: to assure continued compliance, use only shielded interface cables when connecting

to computer or peripheral devices. Any changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to operate this equipment. This

transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

FCC Radiation Exposure Statement

This equipment has been assembled using components that comply with FCC radiation exposure

limits set forth for an uncontrolled environment. This equipment should be installed and operated

with minimum distance 20 cm between the radiator and your body.

This device has been assembled using components that comply with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause

undesired operation.

Industry Canada

This Class A digital apparatus has been assembled using components that comply with Canadian

ICES-003.