User's Manual

7.5 Web-Based Interface Menus

Once logged in successfully, the general mode page will appear as shown in Figure 7.4. Through

this page you can change the mode of operation of the FM unit. The item list menu on the left

can be used to set/ modify the configuration of the unit.

Figure 7.4: FM Unit General Configuration Window

7.6 General Mode

Firmware version 6.5 supports both Prodigy 1.0 and Prodigy 2.0. Prodigy 2.0 is NOT compatible

with Prodigy 1.0. The protocol selection can be done, for back-compatibility, using the

FMQuadro General Mode Configuration page. Please make sure that all the units within the

same network use the same protocol version. No mixed operation of Prodigy 1.0 and Prodigy 2.0 are

allowed. In case of expansion of current network deployments two options are available:

Setting the newly added units with Firmware 6.5 or above to operate in Prodigy 1.0.

Upgrading the previously deployed units with a Firmware 6.5 or above and set them to

operate in Prodigy 2.0.

We recommend option 1.if there is no specific issue in the network.

Every FM unit has three possible modes of operations:

• Bridge Mode

• Mesh Point Mode

• Mesh End Mode

The FM unit factory default mode is Bridge. The Mesh Point mode must be used for any unit