Installation Instructions

Table Of Contents

NOTE

When the General Mode window is opened for the first time,

the Local IP and Local Netmask LAN parameters will be

factory-set default values.

The information needed is self-explanatory. To enter a parameter, click the

field and type the parameter.

If needed, enter the local primary DNS address in the Dns 1 field, and

enter the local secondary DNS address in the Dns 2 field.

Save the LAN settings by clicking the Save button. Alternatively, clear the

settings by clicking the Reset button.

6.4.2. Wireless settings

Modifying the wireless settings

IMPORTANT

If the Fluidmesh 4200 FIBER was purchased in the USA or

Canada, the Country selection is set to the country of

purchase, and the Country: drop-down will be disabled.

The WIRELESS RADIO window contains controls to change the following

settings:

• The shared network passphrase.

• The national territory in which the wireless network is installed.

• The operational radio frequency and bandwidth settings.

To change the Wireless Settings, do the following steps:

1. Click the -wireless radio link under GENERAL SETTINGS in the

left-hand settings menu.

• The WIRELESS RADIO dialog will be shown (Figure 26

(page 70)).

Fluidmesh 4200 FIBER