Installation Instructions

Table Of Contents

RACER configuration files use the *.FMCONF file extension.

If the unit is not connected to the Internet, you can still use the RACER

configuration interface to define a configuration file, then upload it to the

unit. This can be done in either of two different ways:

• A range of ready-made configuration templates are available from

the RACER interface. Each template caters to a particular

configuration scenario, and can be copied and modified to your

needs.

• Alternatively, you can create a new, custom configuration template.

For instructions on how to copy, modify or create a configuration template

using the RACER interface, refer to the Fluidmesh Networks RACER User

Manual.

A configuration file that has been created using the RACER interface must

be uploaded to the unit. To upload a RACER configuration file, do the

following steps:

1. Switch the unit to Offline mode as shown in “Switching between

offline and online modes” (page 62).

2. Click the -RACER™ link in the left-hand settings menu.

• The Configurator landing page will be shown.

3. Click the Choose File button in the Upload Configuration File

section (Figure 22 (page 64)).

Figure 22. Configurator interface (RACER configuration file

upload dialog)

• Find and choose the correct configuration file by following

the software prompts.

4. Click the Upload Configuration button.

• The configuration file will be uploaded and applied to the

unit.

Fluidmesh 4200 FIBER