Installation Instructions
Table Of Contents
- Fluidmesh 4200 FIBER
- Table of Contents
- 1. HAZARDOUS CONDITION WARNINGS
- 2. Reporting mistakes and recommending improvements
- 3. Getting Started
- 4. Hardware installation
- 4.1. Fluidmesh Hardware Installation
- 4.2. Connecting the Fluidmesh Fluidmesh 4200 FIBER to a network and antennas
- 5. Using the Fluidmesh Partner Portal
- 6. Device configuration using the configurator interface
- 6.1. Software and hardware prerequisites
- 6.2. Accessing the Fluidmesh 4200 FIBER for device configuration
- 6.3. Switching between offline and online modes
- 6.4. General settings
- 6.5. Network control
- 6.6. Advanced settings
- 6.6.1. Advanced radio settings
- 6.6.2. SFP settings
- 6.6.3. Static routes
- 6.6.4. Whitelists and Blacklists
- 6.6.5. Multicast
- 6.6.6. SNMP configuration
- 6.6.7. Wireless access point configuration
- 6.6.8. RADIUS configuration
- 6.6.9. NTP Configuration
- 6.6.10. L2TP configuration
- 6.6.11. VLAN settings
- 6.6.12. Fluidity settings
- 6.6.13. Miscellaneous settings
- 6.7. Management settings
- 6.7.1. View Mode settings
- 6.7.2. Changing the Administrator username and password
- 6.7.3. Overwriting and upgrading the unit firmware
- 6.7.4. Plug-In management
- 6.7.5. The device status view
- 6.7.6. Saving and restoring the unit settings
- 6.7.7. Resetting the unit to factory defaults
- 6.7.8. Logging out
- 6.7.9. Viewing the end-user license agreement
- 7. Software Plug-Ins
- 8. Troubleshooting
- 9. Electrical power requirements
- 10. Heat radiation data
- 11. Federal Communications Commission (FCC) radio interference statement
- 12. Notices and copyright
- 13. Fluidmesh end-user license agreement
- 13.1. Preamble
- 13.2. Notice
- 13.3. Definitions
- 13.4. License grant
- 13.5. Uses and restrictions on use
- 13.6. Open-source software
- 13.7. Termination
- 13.8. Feedback
- 13.9. Consent to use of data
- 13.10. Warranty disclaimer
- 13.11. Limitation of liability
- 13.12. Exclusion of liability for emergency services
- 13.13. Export control
- 13.14. General
- 14. Contact us
7.2.2. Deactivating An Active Plug-In .................................................... 157
7.2.3. Reactivating A Deactivated Plug-In ............................................. 159
7.2.4. Exporting And Uploading Multiple Activation Codes ...................... 160
7.2.5. Sharing License Codes And Accepting Shared License Codes ...... 162
8. Troubleshooting .......................................................................................... 163
8.1. I Cannot Get The Log-In Screen .......................................................... 163
8.2. I Cannot Log In To The RACER Interface ............................................. 163
8.3. I Forgot The Administrator Password ................................................... 163
8.4. The Wireless Link Is Poor Or Non-Existent In Bridge Mode .................... 164
9. Electrical Power Requirements ..................................................................... 165
10. Heat Radiation Data .................................................................................. 167
11. Federal Communications Commission (FCC) Radio Interference Statement ... 168
12. Notices And Copyright ............................................................................... 171
13. Fluidmesh End-User License Agreement ..................................................... 173
13.1. Preamble ......................................................................................... 173
13.2. Notice .............................................................................................. 173
13.3. Definitions ........................................................................................ 173
13.4. License Grant ................................................................................... 174
13.5. Uses And Restrictions On Use ........................................................... 174
13.6. Open-Source Software ...................................................................... 175
13.7. Termination ...................................................................................... 176
13.8. Feedback ......................................................................................... 176
13.9. Consent To Use Of Data .................................................................... 176
13.10. Warranty Disclaimer ........................................................................ 177
13.11. Limitation Of Liability ....................................................................... 177
13.12. Exclusion Of Liability For Emergency Services .................................. 178
13.13. Export Control ................................................................................ 178
13.14. General .......................................................................................... 179
14. Contact Us ................................................................................................ 180
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC Page 5 of 180