Installation Instructions

Table Of Contents

• Click the -snmp mode link under ADVANCED SETTINGS in the

left-hand settings menu.

• The default SNMP dialog will be shown (Figure 57 (page

111)).

Figure 57. SNMP dialog (SNMP disabled)

NOTE

By default, Fluidmesh units are shipped from the

factory with SNMP disabled.

Using SNMP v2c

To change the unit's SNMP mode to v2c and configure the unit

accordingly, do the following steps:

1. Click the SNMP mode drop-down, and click the v2c option.

• The SNMP v2c settings dialog will be shown (Figure 58

(page 111)).

Figure 58. SNMP dialog (v2c selected)

2. Enter a community identity value in the Community ID: field.

Fluidmesh 4200 FIBER