Installation Instructions

Table Of Contents

To show all Fluidmesh wireless access points (APs) in the displayed radio

spectrum, do the following steps:

1. Click the Show AP button on the upper right-hand corner of the

Spectrum Graph window.

• An icon representing each available access point will be

shown on the Spectrum Graph window.

2. To see detailed information for an access point, hover the mouse

cursor over the access point icon.

• The SSID number, MAC address and signal strength will

be shown for the chosen AP.

To see detailed information for the signal quality at each point in the

displayed frequency spectrum, click the Show Chan Quality button on

the upper right-hand corner of the Spectrum Graph window.

• A series of vertical bars will be shown for each occupied channel.

• Green bars indicate high signal quality. Yellow bars indicate falling

quality. If a bar is red, there is excessive signal noise at that

frequency.

To close the Spectrum Graph web page, click the Close Window

button on the upper right-hand corner of the Spectrum Graph window.

7.5. Network control

7.5.1. Ping softdog

The PING SOFTDOG window contains controls to set up a constant

series of pings to one or more IP addresses.

If connectivity is lost between the unit and any of the saved IP addresses,

an option can also be set to automatically reboot the Cisco FM3200 Endo.

TIP

As well as being a fail-safe mechanism to monitor network

connectivity, the constant ping can also be used as a 'keep-

alive' message to devices that need uninterrupted connectivity,

such as VoIP telephones.

To use the constant ping and automatic reboot functions, do the following

steps:

1. Click the -ping softdog link under NETWORK CONTROL in the

left-hand settings menu.

• The PING SOFTDOG dialog will be shown (Figure 27

(page 70)).

Cisco Ultra-Reliable Wireless

Backhaul FM3200 Endo