Installation Instructions

Table Of Contents

Device firmware reboot

1. Remove the bottom cover from the main unit enclosure as shown

in “Connecting LAN cables to the unit” (page 35).

2. Insert a long tool with a thin shaft, such as a paper clip or a thin

screwdriver, into the RESET button port until the tool touches the

bottom (Figure 8 (page 31)).

Figure 8. Cisco FM3200 Endo (Hardware RESET button port)

3. Press the RESET button for one second, then release the button

immediately.

• The unit will reboot.

Resetting the unit to factory settings

CAUTION

Do not do a factory reset unless the unit needs to be

reconfigured using its factory configuration as a starting point.

A factory reset will reset the unit's IP address and administrator

password, and will disconnect the unit from the network.

The following methods are available to do a factory reset:

1. To do the reset using the offline Configurator interface, refer to

“Resetting the unit to factory defaults” (page 139).

2. To do the reset using FM Racer, refer to the Fluidmesh Networks

FM Racer User Manual.

3. To do the reset by physically accessing the unit, follow the

procedure below.

To reset the radio to its factory default settings, do the steps that follow:

1. Power ON the unit.

2. Wait approximately 40 seconds for the unit to boot up.

3. When the unit has completed its boot sequence, press the

RESET button for 7 seconds.

Cisco Ultra-Reliable Wireless

Backhaul FM3200 Endo