Installation Instructions

Table Of Contents

IMPORTANT

If a unit is set to Infrastructure (wireless

relay) mode, do not connect the unit to the

wired LAN.

• Vehicle: Choose this setting if the unit is installed on or in

a moving vehicle.

4. If the Unit Role has been set as Vehicle, assign the unit a

vehicle identity using either of the methods below:

• Allow the unit to automatically generate a unique vehicle

identity by checking the Enable check-box to the right of

the Automatic Vehicle ID: heading.

• Assign a vehicle identity manually by un-checking

the Enable check-box to the right of the Automatic

Vehicle ID: heading, and manually entering an

identification string in the Vehicle ID: field.

IMPORTANT

If vehicle identities have been

manually assigned, the Vehicle ID string must

be unique for every individual Fluidmesh unit

operating on the same network, even if more

than one Fluidmesh unit is installed on the

same vehicle.

5. The network type must be set in accordance with the general

network architecture. Select the correct network type designation

for the unit by clicking the Network Type: drop-down and clicking

the correct option from the list below:

• Flat: Choose this setting if the wireless mesh network and

the infrastructure network both belong to a single layer-2

broadcast domain.

• Multiple Subnets: Choose this setting if the wireless mesh

network and the infrastructure network are organized as

separate layer-3 routing domains.

6. Save the Fluidity settings by clicking the Save button.

Alternatively, clear the settings by clicking the Reset button.

Cisco Ultra-Reliable Wireless

Backhaul FM3200 Endo