Installation Instructions

Table Of Contents

Alternatively, enter Edit mode by clicking the Settings icon on the

upper right part of the FM-QUADRO view, and clicking the Edit

Mode switch in the Appearance / Background dialog from Off to

On.

• The Edit mode dialog will be shown.

2. Click the Continue to Edit Mode button to enable Edit Mode.

• A red Edit Mode: ON notification will appear in the view.

3. Click-and-drag any of the stationary device icons or tooltips to

any needed position in the FM-QUADRO view.

• Note that tooltips representing mobile radios do not appear

in Edit Mode.

TIP

If needed, you can add an aerial image to the

FM-QUADRO view. This allows you to

superimpose the network view over a map of

the terrain on which the network has been

installed.

For instructions on how to add an aerial

image, refer to “Adding an aerial map to the

FM-QUADRO view” (page 85).

4. When all device icons and tooltips are in the correct position, click

the Save or discard icon (below).

• The Save new layout dialog will be shown.

5. To save your changes, click the Save changes button.

Alternatively, click the Keep editing button to return to Edit Mode,

or click the Discard button to leave Edit Mode without saving any

changes.

Showing KPI values for wireless links

To show an information ribbon containing key performance indicators next

to all wireless link lines, do the steps that follow:

1. Click the Settings icon on the upper right part of the FM-

QUADRO view (below).

Cisco Ultra-Reliable Wireless

Backhaul FM4200 Mobi