Installation Instructions
Table Of Contents
- Cisco Ultra-Reliable Wireless Backhaul FM4200 Mobi
- Table of Contents
- 1. HAZARDOUS CONDITION WARNINGS
- 2. Reporting mistakes and recommending improvements
- 3. Getting Started
- 4. Installing the radio
- 5. Hardware installation
- 5.1. Fluidmesh Hardware Installation
- 5.2. Connecting the Fluidmesh Cisco FM4200 Mobi to a network and antennas
- 6. Using the Fluidmesh Partner Portal
- 7. Device configuration using the configurator interface
- 7.1. Software and hardware prerequisites
- 7.2. Accessing the Cisco FM4200 Mobi for device configuration
- 7.3. Switching between offline and online modes
- 7.4. General settings
- 7.5. Network control
- 7.5.1. Ping softdog
- 7.5.2. FM-QUADRO
- FM-QUADRO for mesh network-capable devices
- Plotting and interpreting the wireless links
- Viewing live data for a radio or wireless link
- Viewing live RSSI data for a wireless link
- Manipulating the FM-QUADRO view
- Changing the relative position of device icons
- Showing KPI values for wireless links
- Adding an aerial map to the FM-QUADRO view
- Adjusting the transparency of the aerial map view
- Exporting a network representation file
- 7.5.3. Advanced tools
- 7.6. Advanced settings
- 7.6.1. Advanced radio settings
- 7.6.2.
- 7.6.3. Static routes
- 7.6.4. Pass lists and Block lists
- 7.6.5. Multicast
- 7.6.6. SNMP configuration
- 7.6.7. Wireless access point configuration
- 7.6.8. RADIUS configuration
- 7.6.9. NTP Configuration
- 7.6.10. L2TP configuration
- 7.6.11. VLAN settings
- 7.6.12. Fluidity settings
- 7.6.13. Miscellaneous settings
- 7.7. Management settings
- 7.7.1. View Mode settings
- 7.7.2. Changing the Administrator username and password
- 7.7.3. Overwriting and upgrading the unit firmware
- 7.7.4. Plug-In management
- 7.7.5. The device status view
- 7.7.6. Saving and restoring the unit settings
- 7.7.7. Resetting the unit to factory defaults
- 7.7.8. Logging out
- 7.7.9. Viewing the end-user license agreement
- 8. Software Plug-Ins
- 9. Troubleshooting
- 10. Electrical power requirements
- 11. Heat radiation data
- 12. Federal Communications Commission (FCC) radio interference statement
- 13. Notices and copyright
- 14. Fluidmesh end-user license agreement
- 14.1. Preamble
- 14.2. Notice
- 14.3. Definitions
- 14.4. License grant
- 14.5. Uses and restrictions on use
- 14.6. Open-source software
- 14.7. Termination
- 14.8. Feedback
- 14.9. Consent to use of data
- 14.10. Warranty disclaimer
- 14.11. Limitation of liability
- 14.12. Exclusion of liability for emergency services
- 14.13. Export control
- 14.14. General
- 15. Contact us
14. FLUIDMESH END-USER LICENSE
AGREEMENT
14.1. Preamble
This License Agreement strictly prohibits you from using the Fluidmesh
Firmware on any device other than a Fluidmesh Device. You are also
prohibited from removing or modifying any Cisco or Fluidmesh copyright
notice, trademark or user interface of the Fluidmesh Firmware or any
Fluidmesh Device.
The Fluidmesh Firmware is copyright-protected material under United
States and international copyright and other applicable laws.
Unauthorized copying, use or modification of any part of this firmware, or
violation of the terms of this Agreement, will be prosecuted to the
maximum extent allowable under law.
14.2. Notice
This is an agreement between you and Fluidmesh, a division of Cisco
(hereafter known as 'Fluidmesh').
You must read and agree to the terms of this firmware license agreement
(hereafter known as the 'agreement') before any Fluidmesh firmware can
be downloaded, installed or used. By clicking the 'Accept' button on any
Fluidmesh firmware download webpage, or by downloading, installing or
using Fluidmesh firmware and/or by using any Fluidmesh device running
Fluidmesh firmware, you are agreeing to be bound by the terms and
conditions of this agreement. If you do not agree with the terms and
conditions of this agreement, then you should not download, install or use
any Fluidmesh firmware, and you agree to forego any implied or stated
rights to download, install or use Fluidmesh firmware.
14.3. Definitions
For the purpose of this Agreement, the following terms shall have the
following meanings:
'Open Source Software' means any software or software component,
module or package that contains, or is derived in any manner (in whole or
in part) from, any software that is distributed as free software, open
source software or similar licensing or distribution models, including,
without limitation, software licensed or distributed under any of the
following licenses or distribution models, or licenses or distribution models
similar to any of the following: (a) GNU's General Public License (GPL) or
Lesser/Library GPL (LGPL); (b) the Artistic License (e.g., PERL); (c) the
Mozilla Public License; (d) the BSD License; and (e) the Apache License;
'Fluidmesh Device' means a Fluidmesh networking device that you
purchase or otherwise rightfully acquire;
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 170 of 177