Installation Instructions

Table Of Contents

To do a 'hard' (device firmware) reboot under emergency conditions (for

example, if the unit malfunctions), do the steps in the following sub-

section.

Device firmware reboot

1. Remove the bottom cover from the main unit enclosure as shown

in “Connecting LAN cables to the unit” (page 37).

2. Insert a long tool with a thin shaft, such as a paper clip or a thin

screwdriver, into the RESET button port until the tool touches the

bottom (Figure 9 (page 33)).

Figure 9. Fluidmesh 1200 VOLO (Hardware RESET button

port)

3. Press the RESET button for one second, then release the button

immediately.

• The unit will reboot.

Resetting the unit to factory settings

CAUTION

Do not do a factory reset unless the unit needs to be

reconfigured using its factory configuration as a starting point.

A factory reset will reset the unit's IP address and administrator

password, and will disconnect the unit from the network.

The following methods are available to do a factory reset:

1. To do the reset using the configurator interface, refer to “Resetting

the unit to factory defaults” (page 131).

2. To do the reset using RACER, refer to the Fluidmesh Networks

RACER User Manual.

3. To do the reset by physically accessing the unit, follow the

procedure below.

Fluidmesh 1200 VOLO