Installation Instructions

Table Of Contents

• The configuration will be applied, and the unit will reboot.

7.7.7. Resetting the unit to factory defaults

The reset factory default window contains controls that allow you

to restore the Fluidmesh 1200 VOLO to its default factory settings (in

other words, to do a 'hard reset').

IMPORTANT

Doing a hard reset will revert all unit configuration settings,

including the unit's IP address and administrator password, to

factory defaults.

If you want to reboot the unit instead, refer to “Rebooting the

unit” (page 132) below.

To reset the unit to its factory defaults, do the following steps:

1. Click the -reset factory defaults link under MANAGEMENT

SETTINGS in the left-hand settings menu.

• The unit reset dialog will be shown (Figure 69 (page 131)).

CAUTION

Do not do a hard reset unless the unit needs

to be reconfigured using its factory

configuration as a starting point.

A hard reset will reset the unit's IP address

and administrator password, and will

disconnect the unit from the network.

Figure 69. Configurator GUI (unit reset dialog)

2. Reset the unit to its factory defaults by clicking the YES link.

Alternatively, abort the factory reset by clicking the NO link.

• If the YES link was clicked, the unit will do a factory reset,

and will reboot.

3. If you have previously saved a device configuration file for the

unit, you can restore the saved configuration settings to the unit

as shown in “Saving and restoring the unit settings” (page 129).

Fluidmesh 1200 VOLO