Installation Instructions

Table Of Contents

To activate Plug-in Demo mode, do the following steps:

1. Click the Demo Mode button at the bottom of the MANAGE

PLUG-INS dialog.

• The Demo Mode activation dialog will be shown (Figure 65

(page 126)). A countdown timer shows how much Demo

time remains.

Figure 65. MANAGE PLUG-INS dialog (Demo Mode

activated)

2. To leave Demo mode before expiry of the 8-hour trial period, click

the Exit Demo Mode button.

• Demo mode will be deactivated, and the unit will reboot.

3. If the 8-hour Demo mode limit is reached, the unit will reboot and

Demo mode will not be accessible again.

To upload one or more plug-in activation codes, refer to “Plug-in

management procedures” (page 139).

To assign a software plug-in on the Partner Portal to the unit, do the

following steps:

1. Enter the activation code for the plug-in in the Plug-in Activation

Code: field.

2. Click the Add button.

• The plug-in will be activated, and the plug-in functionality

can be used.

• A REMOVE link will be shown in red to the right of the

relevant plug-in description in the Plug-in List.

To deactivate an uploaded software plug-in for use with another

Fluidmesh unit, refer to “Plug-in management procedures” (page 139).

To show and erase the plug-in installation log files, do the following steps:

1. Click the Show Logs button in the Plug-in Installation Logs:

section.

• The log files for plug-in installation will be shown in the

Plug-in Installation Logs: section.

Fluidmesh 1200 VOLO