Installation Instructions

Table Of Contents

• If the Enabled option is selected for a device-configuration

setting, the setting can be modified by ordinary users.

IMPORTANT

If you are logged in to the Configurator interface with

Administrator credentials, you can enable or disable

any device-configuration setting.

If you are logged in to the Configurator interface as

an ordinary user, you will be able to view the device-

configuration settings, but cannot change the

settings.

4. Save the view mode settings by clicking the Save button in the

Allow View Mode Settings section. Alternatively, clear the

settings by clicking the Reset button.

7.7.2. Changing the Administrator username and password

The CHANGE USERNAME AND PASSWORD section contains controls

to change the Administrator's user name and password for the Fluidmesh

unit.

IMPORTANT

Changing the default password to a strong password is an

extremely important step in preventing security breaches.

If you have logged into the configurator interface using default

administrator's credentials, you will see a notification banner at

the bottom of the screen (Figure 61 (page 119)).

Figure 61. Default admin credentials notification banner

Click the banner to change the admin credentials. You will be

taken to the CHANGE USERNAME AND PASSWORD

section.

To change the Administrator's user name and password for the unit, do

the following steps:

1. Click the -remote access link under MANAGEMENT SETTINGS

in the left-hand settings menu.

• The CHANGE USERNAME AND PASSWORD dialog will

be shown (Figure 62 (page 120)).

Fluidmesh 1200 VOLO