Installation Guide

4
STEP 2: REMOVE OLD PARTS
LEFT
LEFT
A: REMOVE CONNECTOR
Remove water supply
connector from bottom of fill
valve by twisting connector nut to
the left (clockwise).
E: REMOVE LEVER
Unscrew tank lever nut by twisting
counterclockwise, remove nut and
pull lever from tank.
F: REMOVE TANK FROM BOWL
Use green tool to unscrew nuts from
under the bowl and remove bolts
from tank.
H: REMOVE GASKET
Remove tank-to-bowl gasket from
below the tank.
G: LAY TANK ON ITS SIDE
Place on a safe and secure surface.
I: REMOVE FLUSH VALVE
LOCKNUT
Using red wrench, twist locknut
(counterclockwise) to remove.
Remove old flush valve from tank.
B: REMOVE OLD LOCKNUT
Use green tool to twist locknut
below tank to the left (clockwise) to
remove from fill valve.
C: REMOVE OLD FILL VALVE
Including refill tube, refill clip and
shank washer. Drain any excess
water into the back panel of
empty packaging by removing fill
valve from tank. (Pull fill valve up)
D: DISCONNECT
FLAPPER CHAIN
Towel
(Optional)
NOTE: Inspect water
supply connector. Replace it if
it is worn, or you don’t know
how old it is, to prevent flooding
and property damage.
5
Pliers
(Optional)
LEFT
Screwdriver
(Optional)
Red Wrench
Green Tool
NOTE: Bolts can be
loosened from inside tank.
NOTE: Keep gasket for identification on Step 4A.
NOTE: May require pliers if stuck.