Installation Guide

NUT
TOILET
BOWL
BOLT
PLASTIC
RETAINER
WASHER
BRASS
WASHER
FLANGE
CLOSED-END
NUT
SCREW
DO NOT USE:
INSTALLATION INSTRUCTIONS
:DEDEEN SLOOT
Bolts in the back two holes secure floor flange. Screws in the
front two holes secure toilet base to floor.
1. Insert bolts, head down, into mounting slots on floor flange.
2. Slide plastic retainer washer down threads to hold bolts in
place. Place a new wax gasket (sold separately) onto bottom
of toilet bowl.
3. Line up holes in toilet base with bolts in floor flange.
Place toilet on top of flange.
4. Place brass washers, then nuts on bolts. Tighten. DO NOT
OVERTIGHTEN or bowl may crack.
5. Through front two holes on base, carefully drill 3/16"
pilot/starter holes in floor.
6. Insert screws. Place brass washers, then closed-end nuts
over screws.
7. Tighten nuts carefully with wrench. DO NOT OVERTIGHTEN
or bowl may crack.
If new bolt caps are needed, use Fluidmaster Model 7115
or 7116.
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675 U.S.A.
www.xthistoilet.com
®
© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product
instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be
liable for any damages resulting from failure to install or maintain the product in accordance
with the product instructions, from abuse or misuse of the product, from use of
non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl
cleaners containing bleach or chlorine.