Installation Guide

12 13
STEP 6: ADJUST HEIGHT OF NEW FILL VALVE
STEP 5: SECURE TANK TO BOWL
A: INSTALL RUBBER WASHERS
Place one rubber washer on each
tank bolt.
B: INSERT BOLTS INTO TANK
Place tank bolts through bottom
holes of tank.
C: SECURE TANK ONTO BOWL
Set tank onto bowl. Place metal
washer and large hex nut on each
bolt under toilet bowl. Using green
tool, tighten hex nuts evenly until
tank is snug and does not rock. Do
not overtighten.
Rubber
washer
A: TWIST FILL VALVE TO ADJUST HEIGHT
Top of fill valve cap should measure roughly 3”
above top of overflow pipe when installed.
TWIST
LEFT
NOTE:
Increasing height allows
more water to fill in the tank.
HOLD
Do Not Move Lock Ring
TOP OF FILL VALVE CAP
TOP OF OVERFLOW PIPE
3"
Fill Valve Cap
Overflow Pipe
*Lever Hole
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
RIGHT
Rubber washer
(Omit for
Kohler
®
Toilets)
Tank
Metal washer
Large hex nut
Bowl
Green Tool