Installation Guide

18 19
STEP 10: FINE-TUNE TANK WATER LEVEL STEP 11: FINE-TUNE FLUSH
A: FLUSH THE TOILET TO
CHECK THE TANK WATER
LEVEL
After the water stops filling the
tank, the water level should be
roughly ½ inch below the top
of overflow pipe to ensure a
proper flush.
A: TEST FLUSH
Drop 3 squares of toilet paper in
bowl then flush.
B: ADJUST FOR MOST EFFICIENT FLUSH
Continue to adjust dial down one setting and flush until
toilet is unable to flush paper properly.
Note: Flapper dial is
pre-set to maximum
setting (9).
C: FINAL SETTING
Once unable to flush, adjust dial up one for final setting.
B: WATER LEVEL IS TOO LOW
Turn the tank water level adjustment screw clockwise to
raise the float. Flush to reset water level.
WATER LEVEL IS TOO HIGH
Turn the water level adjustment screw counterclockwise to
lower the float. Flush to reset water level.
1/2"
Overflow
Pipe
See Step 6A for Full Tank view.
MORE
WATER
FLUSHED
LESS
WATER
FLUSHED
Hint: The higher the
number, the longer the
flapper stays open for
more water flushed.
Tank Water Level
Adjustment Screw
+
–