User Instructions

CAUTIONS BEFORE INSTALLATION
WIRING REQUIREMENTS
THIS PRODUCT MUST BE PLUGGED into a
regular voltage Grounded GFCI outlet (North America 120V AC,
60Hz). The rated power consumption is W.
WARNING: This Product must be on a separated circuit. No other appliance should share the circuit with this
product. Sharing a circuit could cause the branch circuit fuse to blow or the circuit breaker to trip. Continuous
usage under these conditions may result in fire or property damage.
GROUNDING INSTRUCTIONS – This appliance has to be grounded.
This product should be grounded. In the case of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape path
for the current. This product is equipped with a power cord with a ground wire.
DANGER: Improper use of the grounding plug may result in electric shock.
If the power cord or plug needs to be repaired or replaced, do not connect the ground wire to any of the flat pins. The conductor with green strip or
without yellow stripe on the outer insulation surface is grounding wire.
If you do not fully understand the grounding instructions or if you have questions about whether the product is properly grounded, please consult
qualified electrician or maintenance personnel.
This product is for use on a normal 120 V circuit and has a grounding plug that looks like the plug illustrated in sketch A .in Figure 1. A temporary
adapter, which looks like the adapter illustrated in sketches B and C, may be used to connect this plug to a 2-pole receptacle as shown in sketch B if
a properly grounded outlet is not available. The temporary adapter should be plugged into a properly grounded outlet (sketch A) and should be
installed by a licensed electrician. The green colored rigid ear, lug, and the like extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover. Whenever the adapter is used, it must be held in place by the screw.
The product is factory-equipped with a specific power cord and plug that allow connection to the appropriate circuit. Make sure the product is
connected to the same socket as the plug configuration. This product should not use adapters. Do not modify the supplied plug, if it is not suitable for
the socket, please install the appropriate socket by a qualified electrician. If the product must be reconnected using different types of circuits, it
should be reconnected by qualified maintenance personnel.
This product is for use on a normal 120 V circuit and has a grounding plug that looks like the plug illustrated in sketch A in Figure 1. A temporary
adapter, which looks like the adapter illustrated in sketches B and C, may be used to connect this plug to a 2-pole receptacle as shown in sketch B if
a properly grounded outlet is not available. The temporary adapter should be plugged into a properly grounded outlet (sketch A) and should be
installed by a licensed electrician. The green colored rigid ear, lug, and the ike extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover.
Whenever the adapter is used, it must be held in place by the screw.
The use of an extension cord is not recommended or advised. If it is necessary to use an extension cord, use only a three-prong extension cord (one
to one), and a three-slot built-in GFCI receptacle that will accept the plug on this product. The marked rating of the extension cord should be equal
to or greater than the electrical rating of the unit (10amp). Consult a licensed electrician if you are not sure whether the unit is properly grounded.
Remote control power: AAA (1.5V), 2 EA.