User Instructions

REMOTE CONTROL PARING
1. With your Soft Spa 9500 powered OFF, press and hold the AUTO/STOP button on the remote until
the indicating light displays as
2. Plug in and turn on your Soft Spa 9500.
3. All five indicating lights will illuminate, letting you know pairing is complete.
OVERHEATING PROTECTION
Seat temperature will automatically reduce after 3 minutes to prevent overheating.
WARM TIPS
If your Soft Spa 9500 goes unused for more than 72 hours, it will start self-cleaning to ensure clean
water upon next use.
If your Soft Spa 9500 goes unused for more than 72 hours, we recommend unplugging and
releasing all water from the unit.
AUTOMATIC WORKING MODE/STOP
Press the AUTO/STOP button to start automatic cleaning at any time while power is on.
Press again at any time to stop a cleaning cycle in process.
To enter STANDBY MODE, press and hold the AUTO/STOP button until you hear a “ding” three times.
All lights will turn off and power will reduce to < 3W.
QUICK RELEASE
Depress fully to remove bidet. Always move from the base of the bidet, never the seat or lid, to
avoid damage.
ADDITIONAL REMOTE FUNCTIONS
SIDE PANEL INSTRUCTIONS
NOZZLE MANUAL CLEANING
Hold down the Water Temp. button and allow the wand to fully extend.
Remove the white nozzle at the end of the wand and gently wipe with a soft cloth or sponge,
paying special attention to the nozzle.
Reinsert the white nozzle into the wand and press the AUTO/STOP button to retract the wand back
into bidet base.