User guide

MAINTENANCE

SEMI-ANNUALLY

• Test the secondary drive V-belt tension. Adjust, if necessary, to proper

tension (approximately 7 lbs to deflect the belt 1/4”).

• Check the secondary drive V-belt for wear or damage. Replace if

necessary.

• Remove the rear access panel. Test the primary drive poly V-belt

tension. Adjust, if necessary to proper tension (approximately 4-5 lbs to

deflect the belt 3/8”).

• Check the primary drive poly V-belt for wear or damage. Replace, if

necessary.

• Check clamping force.

- Load a container into the mixer

- Fully clamp the container into position.

- Attempt to move the container.

- If the container moves, adjusts the clamping force by tightening the

nut on the handle. Refer to the Service section for further instructions.

• Spray silicone in the door tracks for smooth operation.

• Inspect the door lock linkage for tightness. Refer to the Service section.