User Manual Manual
Fluid Management Customer Service 1 . 800 . 462 . 2466
Blendorama Dispenser | 31
j. Align the end of the label up against the bottom
edge of the gauge knob (the label is cut to size
before leaving the factory).
k. Once in position, press the label rmly onto the
gauge, ensuring it adheres to the gauge along
its full length with no creases or bubbles (use a
clean cloth to apply if necessary).
l. Ret the red gauge to the plunger.
General Maintenance
Gauge label replacement - Model 53 PD (continued)