User Manual Manual

28 | Blendorama Dispenser
Fluid Management Customer Service 1 . 800 . 462 . 2466
f. Carefully place the “0” line (the line below the
numeral) of the label on the marked line of the
gauge.
g. Once in position, press the label rmly onto the
gauge, ensuring it adheres to the gauge along
its full length with no creases or bubbles (use a
clean cloth to apply if necessary).
h. Using a sharp knife or blade cut any excess
label off the end of the gauge that may overlap
the black plastic handle.
i. Ret the gauge to the plunger. Repeat steps (d)
through (h) for the inner (red) gauge label.
General Maintenance
Gauge label replacement - Model 25 PD (continued)