User Manual

Device Startup
15
en
Power connection
WARNING!
Check to make sure the available mains voltage matches the data listed on the
type label attached to the back of the device. Incorrect voltage can cause errors
and malfunctions and may destroy the device.
Make sure the connection data and technical specifications of the power supply
comply with DIN VDE or national requirements. The mains connection cable
must be plugged into a properly installed, grounded shockproof safety wall sock-
et.
Protective contactThe power connection must be equipped with ground contact (protective con-
tact). Use the original power cable (included in scope of delivery) to establish a
connection between the mains wall socket and the mains socket located in the
rear of the device.
WARNING!
To avoid the risk of electrical shock, only use this device when connected to a
properly grounded power supply network.
Potential equalizationThe equipotential bonding is used as a protective measure against the failure of
the protective conductor according to requirements of IEC 60601-1 in the respec-
tively valid version. The installation must be according to the relevant local safety
regulations.
4.3 Mounting the Pump
The device is designed to be suspended from a portable stand or for upright
placement on a device cart.