Owner manual

Technical data
FlexCORä Model CMF Series 14
Fluid Components Intl
Document 06EN003327 Rev. -
2.5 Sensor cable
specification
Basic data 5 x 2 x 0.34 mm
2
twisted and screened in pairs
Diameter Ø12 mm
Color Blue
Length Max. length between converter and sensor is 500 m
Capacitance Max. 41 pf/m. Only requested for Ex-applications
2.7 PROFIBUS
â
Communication
Add-on module
Application All TRANSMITTERS
Communication standard Bell 202 frequency shift keying (f.s.k.) standard
Communication modes · Single loop mode
· Multi-drop mode, 14 slave devices
Communicator Rosemount Hand held communicator type 275
Cable specification
Basic data
Q [mm
2
] CU ³ 0.2 mm
2
/AWG 24
Screen YES (Overall screen)
Loop resistance Min. 230 W
Max. 800 W
Cable capacity £ 400 mF/m
Cable length 1500 m
Twisted pair YES
HART
â
is a registered trademark of the HART Communication Foundation.
2.6 HART
â
Communication
Add-on module
General specification
Profibus device profile Class B, V2.0
Flow transducer block
parameter sets supported Class 03 Coriolis
Applicable standard EN 50170, DIN 19245
Physical layer (transmission
technology) IEC 1158-2
Transmission speed 31.25 kbit/sec.
Number of stations Up to 32 per line segment. Maximum total of 126
Cable Two wire twisted pair
Bus termination Passive line terminaton at both ends
2.8 Input
characteristics
Start batch
Hold/continue
(Hold)
Hold/continue
(Continue)
Stop batch
Reset totalizer
Force output
Freeze output